New baseboards milled, coped, and caulked to your walls, so the line where trim meets floor reads crisp and continuous in every room. Measured, prepped, and installed by one Arlington team.
Every run is milled to your chosen profile, then coped, mitered, and caulked to sit tight to the wall and floor, so the whole room reads as one clean line.
Classic stepped and colonial baseboard profiles that suit most Arlington homes and blend seamlessly with existing door casing.
Six-inch and taller base that gives rooms a grander, more finished proportion under high ceilings and open floor plans.
Clean, square-edge baseboard with minimal reveal for contemporary and transitional interiors that want a crisp, simple line.
Base paired with quarter-round or shoe molding that closes the gap over hardwood and tile for a tidy, durable transition.
Solid oak, maple, or walnut baseboard finished to show the grain, matched to stained trim and hardwood floors.
A single consistent profile carried through every room, hallway, and closet so the trim reads uniform across the entire house.
We walk each room, measure every run and corner, and note floor transitions so nothing is guessed on install day.
We help you choose the baseboard profile, height, and material, painted MDF or stained hardwood, matched to your existing trim.
Your base is cut and prepped by our own carpenters, primed or pre-finished so install goes fast and clean.
We cope inside corners, tighten every miter, nail, caulk, and finish to a crisp line, then leave the space clean.
A lot of baseboard work is nail-gunned in and left with gapped corners and open miters. Ours is measured room by room, coped and fit by hand, and caulked to a tight line, so the trim disappears into the room the way good finish carpentry should.
Most homes are measured, milled, and installed within a few days. Timeline depends on the number of rooms, the profile, and whether the base is painted or stained, which we confirm at your consultation.
Because linear footage, profile, height, and material all change the scope, we quote each home after an in-home consultation. Your estimate reflects the rooms, baseboard, and finish you choose, with no surprises after.
Yes. We mill or source a profile that matches your current base and door casing, so new runs read as part of the original trim rather than an obvious add-on.
We do. We set base to the right height for each floor and add shoe molding or quarter-round where it is needed to close the gap cleanly over hardwood and tile.
Our shop is in Arlington and we install baseboards for homeowners across the Dallas Fort Worth metroplex.
Tell us which rooms you want trimmed. We'll set up an in-home consultation, measure your runs, and walk you through profiles and materials.